Skip to content
Free shipping on orders over €89

Abutment for road bridge cod. 1004

€15,00
SKU: 1004.SPL.H80
Select street level height

H0 scale reproduction (1:87) faithful to the original of the terminal (abutment) which is part of a classic Italian concrete bridge of the current era.

The abutment has 5 hooks and is suitable for the bridge with 5 H beams code 1004

Perfectly reproduced and sized thanks to FDM 3D printing technology with concrete gray like PLA material, it is supplied in a single piece ready for installation.

Available in the following sizes:

  • Height from road level: 80 mm (real life equivalent approximately 7.00 metres) and free height of 58 mm (real life equivalent approximately 5.00 metres)
  • Height from road level: 100 mm (real life equivalent approximately 8.70 metres) and free height of 78 mm (real life equivalent approximately 6.70 metres)
  • Height from the floor road: 120 mm (equivalent to real life about 10.50 meters) and free height of 98 mm (equivalent to real life about 8.50 meters)
  • Road surface height customizable from a minimum of 60 mm to a maximum of 140 mm

Please refer to the dimension drawing below to check the measurements.

The item can already be used raw or can be easily worked and painted for an optimal finish.

Finish of the bioPLA material

Assembly
Where assembly between the pieces is required, we recommend using cyanoacrylate glue for a quick and resistant fixing. We recommend lightly sanding the parts to be glued.

Sanding
To mitigate the streaking effect, you can roughen with 180/240 grit sandpaper and continue with finer grits, up to 1000 for the final sanding. It is recommended to moisten the sandpaper or wet the piece with cold water to avoid overheating the surface too much, as the PLA material could knead at high temperatures.
The use of power tools for sanding is not recommended.

Painting
Use acrylic products of the desired color with a matt finish (for cement, gray RAL 7035). To obtain a more uniform surface, the use of an airbrush or spray can is recommended. You can apply multiple coats until you are satisfied, leave to dry between coats.

0 / 0
Go to top Top