Skip to content
Free shipping on orders over €89

Span for road bridge with 5 H beams cod. 1004

SKU: 1004.TRV.L253
Select Span length

Reproduction in H0 scale (1:87) of a complete span of 5 H-beams and street level slab of a classic concrete road bridge for urban or service roads. Suitable for roads with a carriageway width of 3.00 meters in each direction, without pavements.

A piece of considerable size and complexity, perfectly reproduced and sized thanks to FDM 3D printing technology with cement gray like PLA material, it is supplied in a single piece, ready to be combined with the pillars and the terminal abutment with master code 1004, obtaining a viaduct of the desired length.

The width of the insole is 85 mm, available in the following length sizes:

  • Span length: 253 mm (equivalent to real life approximately 22 metres)
  • Span length: 287 mm (equivalent to real life approximately 25 metres)
  • Span length: 310 mm (equivalent to real life approximately 27 metres)
  • Customizable from a minimum of 172 mm to a maximum of 345 mm

They are included in the article:

  • 2 non-pedestrian pavements 7 mm wide, laser engraved and cut, full length
  • 2 rows of full-length side finishing tiles
  • 4 gutters 3D printed in resin


The item can already be used raw or can be easily worked and painted for an optimal finish.


Please refer to the dimensioned drawing to check the total width of the bridge (85 mm), the road surface (71 mm) and the non-pedestrian sidewalks (7 mm).

Finish of the bioPLA material

Where assembly between the pieces is required, we recommend using cyanoacrylate glue for a quick and resistant fixing. We recommend lightly sanding the parts to be glued.

To mitigate the streaking effect, you can roughen with 180/240 grit sandpaper and continue with finer grits, up to 1000 for the final sanding. It is recommended to moisten the sandpaper or wet the piece with cold water to avoid overheating the surface too much, as the PLA material could knead at high temperatures.
The use of power tools for sanding is not recommended.

Use acrylic products of the desired color with a matt finish (for cement, gray RAL 7035). To obtain a more uniform surface, the use of an airbrush or spray can is recommended. You can apply multiple coats until you are satisfied, leave to dry between coats.

0 / 0
Go to top Top