Skip to content
Free shipping on orders over € 99 in Europe

Type B pillar for road bridge cod. 1002

€9,50
SKU: 1002.PLB.H80
Select street level height

Reproduction in H0 scale (1:87) faithful to the original of a pillar with 2 piles and beveled cap forming part of a classic Italian concrete bridge of the current era.

The pillar has 7 hooks on each side and is suitable for the bridge with 7 H beams code 1002

Perfectly reproduced and sized thanks to FDM 3D printing technology with concrete gray like PLA material, it is supplied with a cap and 3 piles to glue.

Available in the following sizes:

  • Height from road level: 80 mm (equivalent to real life about 7.00 meters) and free height of 58 mm (equivalent to real life about 5.00 meters)
  • Height from road level: 100 mm (equivalent to real life approximately 8.70 metres) and free height of 78 mm (equivalent to real life approximately 6.70 metres)
  • Height from the floor road: 120 mm (equivalent to real life about 10.50 meters) and free height of 98 mm (equivalent to real life about 8.50 meters)
  • Road surface height customizable from a minimum of 60 mm to a maximum of 140 mm (free height always 22 mm less)

Please refer to the dimension drawing below to check the measurements.

The item can already be used raw or can be easily worked and painted for an optimal finish.

Finish of the bioPLA material

Assembly
Requires quick assembly. It is equipped with joints for easy and precise positioning. Use cyanoacrylate glue for fast and resistant fixing. We recommend lightly sanding the parts to be glued.

Sanding
To mitigate the streaking effect, start by roughing with 180/240 grit sandpaper and continue with finer grits, up to 1000 for the final sanding. It is advisable to moisten the sandpaper or wet the piece with cold water to avoid overheating the surface too much, as the PLA material may not mix at high temperatures.
The use of power tools for sanding is not recommended.

Painting
Painting with Primer: after cleaning and drying the piece, use an acrylic-based spray primer, white or light grey. Also useful for further leveling the surface. Give at least 2 light passes. Once dry it can also be sanded with 600/800 grit paper. The process can be repeated until you are satisfied, but without exaggerating.
Final painting: use acrylic products of the desired color with a matt finish (for concrete, gray RAL 7035). To obtain a more uniform surface, the use of an airbrush or spray can is highly recommended. You can apply multiple coats until you are satisfied, let it dry between coats.

0 / 0
Go to top Top