Span for road bridge with 5 H beams cod. 1004

€29,00

Span for road bridge with 5 H beams cod. 1004

€29,00

SKU: 1004.TRV.L253

Select Span length

253 mm

287mm

310 mm

Personalized

Reproduction in H0 scale (1:87) of a complete span of 5 H-beams and street level slab of a classic concrete road bridge for urban or service roads. Suitable for roads with a carriageway width of 3.00 meters in each direction, without pavements.

A piece of considerable size and complexity, perfectly reproduced and sized thanks to FDM 3D printing technology with cement gray like PLA material, it is supplied in a single piece, ready to be combined with the pillars and the terminal abutment with master code 1004, obtaining a viaduct of the desired length.

The width of the insole is 85 mm, available in the following length sizes:

Span length: 253 mm (equivalent to real life approximately 22 metres)
Span length: 287 mm (equivalent to real life approximately 25 metres)
Span length: 310 mm (equivalent to real life approximately 27 metres)
Customizable from a minimum of 172 mm to a maximum of 345 mm

They are included in the article:

2 non-pedestrian pavements 7 mm wide, laser engraved and cut, full length
2 rows of full-length side finishing tiles
4 gutters 3D printed in resin

Finish

The item can already be used raw or can be easily worked and painted for an optimal finish.

Measures

Please refer to the dimensioned drawing to check the total width of the bridge (85 mm), the road surface (71 mm) and the non-pedestrian sidewalks (7 mm).

Additional Information

Finish of the bioPLA material

Assembly
Where assembly between pieces is required, we recommend using cyanoacrylate glue for a quick and strong bond (Glue 21, available in the Accessories category, is perfect). We recommend lightly sanding the parts to be glued.

Sanding
Normally not necessary, but if you want to reduce the streaking effect, you can roughen with 240/320 grit sandpaper and then work your way up to finer grits, up to 1000 for the final sanding. We recommend wetting the sandpaper or wetting the piece with cold water to avoid overheating the surface, as the PLA material could become brittle at high temperatures.
The use of power tools for sanding is not recommended.

Painting
Use acrylic paints in the desired color with a matte finish (for concrete, RAL 7035 gray). For a more uniform surface, we recommend using an airbrush or spray can. You can apply multiple coats until you're satisfied, letting them dry between coats.