Skip to content
Free shipping on orders over €89

1 track tunnel - Curves radius 490

€9,00
SKU: 1051.R490.L80
Select Title

H0 scale reproduction (1:87) of an internal tunnel for single track railway lines.

Adapt it to lines with medium curves with a radius of 490 millimeters (radius R3 - R4) and must be combined with the corresponding portal for the same type of radius (initial code 1050.R490).

Each tunnel is 8 cm long and it is possible to extend it with other elements of the same type.
It makes no difference whether it curves left or right and is suitable for both lines with and without catenary.

It is equipped with an upper hole to facilitate the insertion of a possible anchoring system for the overhead line.

3D printed with FDM technology in ecological dark gray PLA material, it is supplied to be painted.

Finishing of bioPLA tunnels

Tunnel H0 finish
The tunnel is supplied in a single piece, it does not require assembly. It can be assembled to the portal or to other items of the same type. Use cyanoacrylate glue for fast and resistant fixing.

Surface preparation
Give it a light sanding with 180/240 grit sandpaper and possibly a second pass with a finer grit. With the piece clean and dry, you can use a spray putty to even out the surface and eliminate streaks from the print.
Alternatively, a light layer of plaster and vinyl glue can be applied to the inside of the tunnel. To be sanded once dry.

Painting
Painting can be done with opaque acrylic colours. A dark gray color is recommended.
Subsequent passes can be carried out with various highlighting techniques to highlight flows of water and moss in order to dirty and make the painting less uniform.

0 / 0
Go to top Top