Skip to content
Free shipping on orders over €89

Single track abutment for "Modena" H0 viaduct

€21,00
SKU: 1001.SPS.H66
Select track surface height

Reproduction in H0 scale (1:87) faithful to the original of the single track terminal (shoulder) of the "Modena" viaduct used in real life on the Milan-Bologna high-speed route and in the new variant of the historic route near Modena.

Perfectly reproduced and sized thanks to FDM 3D printing technology with concrete like gray PLA material, it is supplied in a single piece, ready.

Available in the following sizes:

  • Height from track surface: 66 mm (equivalent to real life approximately 5.7 metres)
  • Height from track surface : 80 mm (equivalent to real life approximately 7.0 metres)
  • Height from track surface : 100 mm (equivalent to real life approximately 8.7 metres)
  • Customizable from a minimum of 66 mm to a maximum of 120 mm

The item can already be used raw or can be easily worked and painted for an optimal finish.

Please refer to the following drawing to correctly calculate the necessary measurements.

Finish of the bioPLA material

Assembly
Requires quick assembly. It is equipped with joints for easy and precise positioning. Use cyanoacrylate glue for fast and resistant fixing. We recommend lightly sanding the parts to be glued.

Sanding
To mitigate the streaking effect, start by roughing with 180/240 grit sandpaper and continue with finer grits, up to 1000 for the final sanding. It is advisable to moisten the sandpaper or wet the piece with cold water to avoid overheating the surface too much, as the PLA material may not mix at high temperatures.
The use of power tools for sanding is not recommended.

Painting
Painting with Primer: after cleaning and drying the piece, use an acrylic-based spray primer, white or light grey. Also useful for further leveling the surface. Give at least 2 light passes. Once dry it can also be sanded with 600/800 grit paper. The process can be repeated until you are satisfied, but without exaggerating.
Final painting: use acrylic products of the desired color with a matt finish (for concrete, gray RAL 7035). To obtain a more uniform surface, the use of an airbrush or spray can is highly recommended. You can apply multiple coats until you are satisfied, let it dry between coats.

0 / 0
Go to top Top