Span for road bridge with 6 H beams cod. 1202

€13,00

Span for road bridge with 6 H beams cod. 1202

€13,00

SKU: 1202.TRV.L138

Select Span length

138mm

156 mm

169mm

Personalized

Reproduction in N scale (1:160) of a complete span of 6 H-beams and street level slab of a classic concrete road bridge for provincial and main high-flow roads. Suitable for roads with a carriageway width of 3.25 meters at ground level + side shoulder and non-pedestrian pavement.

Perfectly reproduced and sized thanks to FDM 3D printing technology with concrete gray like PLA material, it is supplied in a single piece, ready to be combined with the pillars and the terminal abutment with master code 1202 to obtain a viaduct of the desired length.

The width of the bridge slab is 56 mm, available in the following length sizes:

Span length: 138 mm (equivalent to real life approximately 22 metres)
Span length: 156 mm (equivalent to real life approximately 25 metres)
Span length: 169 mm (equivalent to real life approximately 27 metres)
Customizable from a minimum of 100 mm to a maximum of 188 mm

They are included in the article:

2 full-length laser-engraved and laser-cut sidewalks
2 rows of full-length side finishing tiles

Finish

The item can already be used raw or can be easily worked and painted for an optimal finish.

Measures

Please refer to the dimensioned drawing to check the total width of the bridge (56 mm), the road surface (46 mm) and the pavements (5 mm).

Additional Information

Finish of the bioPLA material

Assembly
Where assembly between pieces is required, we recommend using cyanoacrylate glue for a quick and strong bond (Glue 21, available in the Accessories category, is perfect). We recommend lightly sanding the parts to be glued.

Sanding
Normally not necessary, but if you want to reduce the streaking effect, you can roughen with 240/320 grit sandpaper and then work your way up to finer grits, up to 1000 for the final sanding. We recommend wetting the sandpaper or wetting the piece with cold water to avoid overheating the surface, as the PLA material could become brittle at high temperatures.
The use of power tools for sanding is not recommended.

Painting
Use acrylic paints in the desired color with a matte finish (for concrete, RAL 7035 gray). For a more uniform surface, we recommend using an airbrush or spray can. You can apply multiple coats until you're satisfied, letting them dry between coats.